Choose a country:

Toll information for Czech Republic

The Czech toll system MYTO CZ applies to vehicles and buses > 3.5 t maximum allowed weight. In this distance-based toll system, toll charges are electronically debited via the so-called Premid-Box (On-Board-Unit/OBU), and settled directly through DKV Mobility– using either the pre-pay or post-pay procedure.

Toll provider: MYTO CZ

General information

Czech Republic

Valid for vehicles	Routes	Billing option
> 3,5 t	Freeways, selected federal roads	Myto CZ OBU / DKV CARD
	Freeways, selected federal roads	Vignette

Information on the CO2 toll in the Czech Republic

The EU has set itself the target of reducing CO2 emissions in road transport by 30% (compared to 2005). The categorisation in a toll tariff is therefore extended by the categorisation in a CO2 class.

The CO2 toll tariffs have been in force in the Czech Republic since 01.03.2024 and affect vehicles over 3.5 tonnes.

Below you will find questions and answers about the submission process. Additional information can also be found on the MYTO CZ page.

Overview of current toll tariffs in the Czech Republic

Which vehicles are affected by the CO2 toll in the Czech Republic?

The CO2 toll in the Czech Republic applies to vehicles over 3.5 tonnes.

Buses are assigned to CO2 class 1 by default, except for electric or hydrogen buses, which are assigned to CO2 class 5.

Electric or hydrogen-powered vehicles over 4.25 tonnes are not affected by the toll for air or CO2, but pay the partial toll rate for infrastructure and noise.

Vehicles between 3.5 and 4.25 tonnes must be registered at a contact point with an "OBU exemption" (unfortunately DKV Mobility cannot carry out this registration for you in the FCI portal of Czechtoll).

Post-Pay customers │ What proof do I need to provide for the CO2 class in the Czech Republic?

For vehicles with a CO2 class better than 1, you can upload the registration certificate part 1 and the certificate of conformity (COC) in the DKV Cockpit .

If you have already done this for Austria and/or Germany or your vehicle was first registered before 1 July 2019, it is not necessary to upload it again. The date of first registration can be found on the vehicle registration document in field B. In this case, it is also not necessary to submit a new authorisation.

The processing time on the part of Czechtoll is 5 working days from transmission by DKV Mobiliy, for complaints 1-2 working days.

Pre-Pay customers │ How do I register my CO2 class in the Czech Republic?

As a Pre-Pay customer, you have three options for registering your CO2 class in the Czech Republic:

Send your proofs by e-mail to Czechtoll(info@mytocz.eu) and you will receive a reply by e-mail.
Log in via Czechtoll's Customer Self Care Portal (this is Czechtoll's preferred option: https://mytocz.eu/selfcare/logon/) .
Register via local contact and distribution centres(https://mytocz.eu/de/customer-points/list) , but please note that there may be language problems. You will receive a confirmation of your CO2 class on site.

Are electric vehicles and H2O vehicles exempt from the toll?

The vehicles were exempt from the tax until 01.03.2024. From now on, only vehicles under 4.25 tonnes that use only electricity or hydrogen as fuel will be exempt from the toll.

Electric and H2O vehicles over 4.25 tonnes must pay charges for infrastructure and noise emissions, but not the surcharge for pollutant/CO2 emissions.

Further information on our page on the CO2 toll in the EU

Guideline for trucks

The free-of-charge Premid-Box is available on payment of a deposit in the equivalent amount of 54 Euro to the Czech toll operator.

General company information: Confirm your data
Vehicle Registration: Confirm vehicles and add new ones
Finalize your order: Confirm the order

The cost of the Czech Republic toll is currently about 14 cents/km depending on the pollutant class and number of axles. Tolls are composed of axle categories and Euroclasses.

Toll section tariffs (PDF)

Toll roads

The following weight classes are used as basis:

Vehicle category: over 3.5 t - 7.5 t
Vehicle category: 7.5 t - 12 t
Vehicle category: over 12 t

Payment

Pre-pay procedure

When passing the toll stations the toll is electronically debited via the Premid-Box, which was pre-loaded with credit at one of the Premid-Box distribution points

Post-pay procedure

The fully electronic toll network records the kilometres actually covered. Toll charges are settled afterwards, simply and conveniently, via the Premid-Box so there is no need to constantly load credit. This procedure is especially suitable for frequent drivers.

The deposit is settled in the following DKV invoice, and will be reimbursed when the OBU has been properly returned.

Further information about returning the box

Benefits for DKV Mobility customers

Single-source billing transparent, practical and clear
Using electronic debiting enables you to passthe toll station without stopping
Distinct liquidity advantage thanks to the generous terms of payment implied by the post-pay procedure via DKV Mobility

Contact

Would you also like to benefit from the DKV advantages?

We will be pleased to call you back.

Hello .

Please enter your company name.

Please enter your email address.

Please enter your phone number so we can contact you.

For further information please read our data protection declaration.

* Mandatory field